-12%

DC12V LED Display Automation Delay Timer Control Switch Multifunction Self-lock PLC Cycle Delay Time Relay Module with case


Compare
  1. New upgrades to simplify,to meet customer needs.
  2. Increase the supply anti-reversefunction.
  3. The use of opto isolated input and output,enhanced anti-jamming capabilit consumption.
  4. Set parameter after power for ever memories.
  5. Signal terminal voltage signal can be maintained for a longtime.
  6. to ensure stability,industrial grade board,class PLC.

885.00 1,000.00 Incl. GST

Working mode selection:

  • After power on,long press K12 seconds later into the select function mode,P1-1~P1-4forchoose.
  • P1-1 operating modes:a signal to trigger relay, time is up,the relay
  • disconnect users,You can set relay time T,click K2 the hundreddigital
  • tube starts flashing,then press K3, the hundred digital change;click K2
  • ten digital tube starts flashing,then press K3,ten digit changes;click K2
  • bit digital tube starts flashing, then press K3, single-digit change;then
  • click K2,; digital pipe does not blink,then press the K3, shifting the
  • decimalpoint,the decimalpointin abitindicates 0-999minutesin ten
  • represents 0 to 99.9 seconds withou tadecimalpointrepresents 0-999
  • seconds;goodchoice,bringing the time setting is completed.Short press
  • K1,enterfunction offine-tuning settings,triggerthedefaultdelayperiod
  • is invalid, press K1, during the delay trigger active(re-timing),clickon
  • the K1, during the delay reset (timer turned off,the relay reset) press
  • again to repeat the default settings for the first time.
  • P1-2 operating modes:Asignal trigger ,digital countdown begins,X
  • seconds after,there lay open Y seconds,then close.Users can set the relay
  • time X,Y;P1-1different time settings similar to the blue lights that set
  • the relay time,blue light indicates setting relay off time. Short press K1,
  • enter function offine-tuning the set,the default trigger is invalid during
  • the delay,pressK1,during the delay trigger active(re-timing),then click
  • the first repeat default settings.
  • P1-3 operating modes:Open X seconds,disconnect Yseconds, infinite
  • loop.Users can set the relay timeX,Y;time setting similar to P1-2.Short
  • press K1,enter function offine-tuning set,The default function is:set up
  • an electric circuit the relay first open, press the K1,there lay first
  • close.Press again to repeat the default functionality.
  • P1-4 operating modes:a signal to trigger the relay open but do not start
  • the timer,when the trigger signal disappears,digital count down begins,X
  • time after,the relayclose; During the delay,again to the signal,digital
  • count down canceled, stays energized, the signal disappears, restart
  • count down; (equivalentto release the button to start timing, commonly
  • usedin power-offdelay).Users canset the relay time X; time setting similar to P1-1.
Category:

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “DC12V LED Display Automation Delay Timer Control Switch Multifunction Self-lock PLC Cycle Delay Time Relay Module with case”

There are no reviews yet.

0